Mirage OM7 Technical Information download pdf (Page 10)

Packing the Reserve Container

Pull Bodkin/T-Bar and pull up cord through the freebag.

Then thread pull up cord through closing loop. Tie off

with bowline knot about 6 inches up. [Fig. 19]

Helpful Hint: Treat pull up cord and top 1/2 inch of

the closing loop with Airtec approved silicon. Airtec

recommends the use of silicon to protect the Cypres

loop. It also helps with reserve pin insertion.

Reserve Closing Loop

Canopy Size Loop Length

PD-113 rsv 3.75" +/- 1/4"

PD-126 rsv 4.00" +/- 1/4"

PD-143 rsv 4.25" +/- 1/4"

PD-160 rsv 4.50" +/- 1/4"

PD-176 rsv 4.75" +/- 1/4"

PD-193 rsv 5.25" +/- 1/4"

PD-218 rsv 6.00" +/- 1/4"

PD-253 rsv 6.00" +/- 1/4"

Here is a suggested reserve closing loop length chart.

Prestretched loops are measured from the washer to

the end of the closing loop. [Fig. 18]

IMPORTANT: Reserve ripcord pull force must remain

under 22 lbs pull force.

Helpful Hint: A label in the main packing tray lists the

canopies that are compatible with the container. Also

included are more recommendations on closing loop

length.

Place the reserve freebag into the reserve pack tray

and align risers. [Fig. 20]

Fig. 18

Fig. 19

Fig. 20

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 39 40

No comments

Mirage OM7 Technical Information Page 10