Assembly & User InstructionsMirage 38,200BtuHeat Focusing Patio HeaterThese instructions are for your safety. Please read themthoroughly before us
Page 9Assembly Step 71/4″ Dome Hex Bolt (C)Feed the lantern hose down the support pole and secure lantern to support pole using 4 of the 1/4″ Dome Hex
Page 10Assembly Step 8RegulatorConnect the lantern hose to the regulator hose and secure tightly with adjustable wrenches. Then attach the regulator t
Page 11Assembly Step 9Reector handleFitting reector handleUsing the pre-tted R-clip and pin, secure the reector handle to the bracket as shown.Re
Page 12Assembly Step 10Top PanelLoosely screw parasol side panels together overlapping as shown below. Fix the toppanel to the top of assembled side p
Page 13For all appliances:• The heater, when installed, must be electrically grounded in accordance with local codes or, in the absence of local codes
Page 14Leak Testing• To be performed in a well ventilated area.• Conrm all control knobs are in the o position.• Open the gas control valve on the b
Page 15Use InstructionsBefore proceeding make sure you understand the warnings section of this manual.Lighting instructions:• Fit battery to sparker.•
Page 16• When using the heater after extended periods of storage, re-attach the reector.The heater should never be operated without the reector in p
Page 17CAUTION• It is normal for the heater to smoke during the rst few minutes of use.• If you smell gas – turn o the appliance and extinguish all
Ref Description Illustration Qty Ref Description Illustration QtyParts Supplied123456BaseCylinder ChamberSuppor
Page 2Fixings SuppliedRef Description Illustration Qty Ref Description Illustration QtyABC1/4″ Nut1/4″ Dome He
Page 3Assembly Step 1Base Cylinder ChamberSupports (A,B,C)1/4″ bolt (C)Fix the cylinder chamber supports (A,B,C) to corresponding location on the base
Page 4Assembly Step 2LowerSupport Pole1/4″ Nut (A) 1/4″Dome Hex Bolt (C)Fix lower support pole to cylinder chamber supports as shown using 6 of the 1/
Page 5Assembly Step 3CylinderChamber Wall1/4″ DomeHead Bolt (B)1/4″ Nut(A)Fit the cylinder chamber wall to the cylinder chamber supports using 6 of th
Page 6Assembly Step 4CylinderChamber doorHang door on hinges. Ensure correct alignment and tighten all bolts securely.CylinderChamber doorHinges
Page 7Assembly Step 5CylinderChamber Top1/4″ Dome HexBolt (C)1/4″ Nut(A)CylinderChamber Top1/4″ Washer (D)Fit cylinder chamber top onto cylinder chamb
Page 8Assembly Step 61/4″ Dome Hex Bolt (C)Fit upper support pole to lower support pole using 3 of the 1/4″ dome hex bolts (Ref.C) and washers (Ref.D)
Comments to this Manuals