Mirage HDMirage16-TTSP Instruction Manual

Assembly & User InstructionsMirage 38,200BtuHeat Focusing Patio Heater with Speaker + LightThese instructions are for your safety. Please read the

Page 9Assembly Step 71/4″ Dome Hex Bolt (C)Feed the lantern hose down the support pole and secure lantern to support pole using 4 of the 1/4″ Dome Hex

Page 10Assembly Step 8RegulatorConnect the lantern hose to the regulator hose and secure tightly with adjustable wrenches. Then attach the regulator t

Page 11Assembly Step 9Reector handleFitting reector handleUsing the pre-tted R-clip and pin, secure the reector handle to the bracket as shown.Re

Page 12Assembly Step 10Top PanelLoosely screw parasol side panels together overlapping as shown below. Fix the toppanel to the top of assembled side p

Page 13Assembly Step 11Speaker and Lights1. Charge power bank using cable and plug supplied.2. Connect light and speaker USB cable to power bank.3. Po

Page 14For all appliances:• The heater, when installed, must be electrically grounded in accordance with local codes or, in the absence of local codes

Page 15Leak Testing• To be performed in a well ventilated area.• Conrm all control knobs are in the o position.• Open the gas control valve on the b

Page 16Use InstructionsBefore proceeding make sure you understand the warnings section of this manual.Lighting instructions:• Fit battery to sparker.•

Page 17• When using the heater after extended periods of storage, re-attach the reector.The heater should never be operated without the reector in p

Page 18CAUTION• It is normal for the heater to smoke during the rst few minutes of use.• If you smell gas – turn o the appliance and extinguish all

Ref Description Illustration Qty Ref Description Illustration QtyParts Supplied123456BaseCylinder ChamberSuppor

Page 2Fixings SuppliedRef Description Illustration Qty Ref Description Illustration QtyABC1/4″ Nut1/4″ Dome He

Page 3Assembly Step 1Base Cylinder ChamberSupports (A,B,C)1/4″ bolt (C)Fix the cylinder chamber supports (A,B,C) to corresponding location on the base

Page 4Assembly Step 2LowerSupport Pole1/4″ Nut (A) 1/4″Dome Hex Bolt (C)Fix lower support pole to cylinder chamber supports as shown using 6 of the 1/

Page 5Assembly Step 3CylinderChamber Wall1/4″ DomeHead Bolt (B)1/4″ Nut(A)Fit the cylinder chamber wall to the cylinder chamber supports using 6 of th

Page 6Assembly Step 4CylinderChamber doorHang door on hinges. Ensure correct alignment and tighten all bolts securely.CylinderChamber doorHinges

Page 7Assembly Step 5Drinks Table 1/4″ Dome HexBolt (C)1/4″ Nut(A)Secure drinks table brackets to all 3 of the cylinder chamber support legs at the po

Page 8Assembly Step 61/4″ Dome Hex Bolt (C)Fit upper support pole to lower support pole using 3 of the 1/4″ dome hex bolts (Ref.C) and washers (Ref.D)