Mirage OASIS Owner's Manual download pdf (Page 4)

Hobie MirageDrive

Drive Installation

1. The Hobie MirageDrive® must be

lowered into the opening of the hull

near the footwells so it is facing forward

and evenly front to back. The front of

the MirageDrive can be determined by

the location of the fin masts. Tipping

the drive forward or aft when lowering

can cause it to wedge into the well and

possibly cause damage to the hull and/

or fins. The MirageDrive alignmenet pin

helps prevent this, so make sure that it

properly seats in the groove.

FORWARD

Pedal Adjustment

The pedals of the Hobie MirageDrive are adjustable to

accommodate different leg lengths of kayakers. To adjust

the pedals:

1. Squeeze the adjuster

handles located on the pedal

cranks.

2. While squeezing the

adjuster handle, move the

pedal crank to the most

comfortable position. Similar

to a bicycle, it is best to adjust

the pedals so your legs do

not fully extend causing your

knees to lock. Make sure that

the metal pin on the crank fully

engages the adjustment hole.

3. Hobie Cat

® recommends new

users have the pedal length adjustment set in the middle

(number 4) to help while installing it into the hull correctly.

Once installed you can select your preferred length setting.

Stainless

Steel Masts

2. To lock the MirageDrive into the hull, lower it into the hull

so that the drum shaft posts drop down into the Click and Go

cams and lock into place.

3. To remove the MirageDrive, flip the

Click and Go cam back and pull the drive

out. The cams should automatically reset

themselves for installation, but if they do

not, just flip the cam forward.

Alignment

1 2 3 4 5 6 7 8 9 ... 15 16

Comments to this Manuals

No comments

Mirage OASIS Owner's Manual Page 4

Comments to this Manuals